Turbo Coupe 8.8

[Speed Kills]

FS: Disc Brake Turbocoupe 8.8 rear with 3.55s, sat for a while, still turns fine, not sure abotu the calipers.

Need it out of my garage

$100

[JIMS SVT]

Will this work in a 90 mustang?

[Stangman]

Jim, it will bolt in, but will be wider by about 3/4 to an inch on each side, you would have to run a different offset rim, or buy the brake relocation brackets from www.northracecars.com, (thanks to 50calypso93lx for that one) in order to bring it back to fox length.

And Speed Kills, that '55 is beautiful!

[Speed Kills]

Like stangman said, it will work, but it does push each wheel out +/- .75. IIRC it's almost the exact same width as an SN95 rear

And thanks for the compliment Jesse

[Stangman]

no prob :bigthumb

[5.0calypso93lx]

Will this work in a 90 mustang?

Like everyone else said, It'll work fine, you'll just probably be limited on wheel selection. You could run any aftermarekt ford wheel up to 8" and still be ok, like bullits, 98 cobra's, etc.

Definately a good cheap way to go to rear discs!

[NXcoupe]

FS: Disc Brake Turbocoupe 8.8 rear with 3.55s, sat for a while, still turns fine, not sure abotu the calipers.

Need it out of my garage

$100
Where are you located? Can you PM me a phone number?

[Speed Kills]

Price drop $85 FIRM picked up or $100 delivered in the greater cincinnati area

[seanm]

Or you can put the Mustang backing plates,brake drums and axles in it and be the same as a Mustang .The housings are the same width its the axles that are longer to make room for the rear disc components .

[vincent brick]

It's my garage it's in too and I'd like it gone as well, so here's a pic :)

http://diablo0.servehttp.com/neonstuff/org/vinny/forsale/8pt8.JPG

[Dirtyd0g]

Where is it located?

[vincent brick]

Kenwood/Deer Park.

I am the seller's roommate if there is any confusion.

[8NO4CYL]

Sent you a pm.

[vincent brick]

This is sold.