Master Cylinder Removal

[fst 5pto]

Ok, as far as I know you take the two nuts off and the MC should come off, right? WRONG!!!! I got both nuts off and one of the sides wants to come off but the other is stuck? Need Help! What should I try?

[Paul408Notch]

prybar?

[fst 5pto]

Tried that.... just moves the entire MC and brake booster.... also soaked it in PB Blaster and still no luck...

[Paul408Notch]

So you tried prying between the MC and Booster? When I replaced my MC for my Baer kit, the old one just unbolted and slid right off. There didn't seem to be any kind of binding at all.

Maybe put the nut back on the side that's loose and it'll un-bind the other side?

[fst 5pto]

Ill give it a try... this thing is a PITA!!!!

[fst 5pto]

Finally got it off last night... ended up taking an air hammer and it came off in 2 seconds... damn pry bars aint worth shit lol!

[5.0calypso93lx]

Finally got it off last night... ended up taking an air hammer and it came off in 2 seconds... damn pry bars aint worth shit lol!

I'm thinking more along the lines of operator error :lol:

[fst 5pto]

Lol highly doubt that.... shouldve let your ass come over and try it... I had three people try and pry that thing off... unless of course there were three cases of operator error?

[5.0calypso93lx]

Lol highly doubt that.... shouldve let your ass come over and try it... I had three people try and pry that thing off... unless of course there were three cases of operator error?

Mine came off just fine :D

[fst 5pto]

Yea whats the mileage difference between ours lol? Are we going to have to wait another 5 years to see this thing out again?