OrangeStang04
05-21-2007, 09:45 PM
Ok... SO i have a problem... I need to know how to wire the MSD Digital Window switch into my Nitrous System.... it is the Zex Dry system.
What I know:
Red: To 12v power
Black: To ground
White: To RPM siginal
What I need to know: Which one of these do I use?
Gray:Normally closed; This will remove the ground source at your desired ON rpm range and complete the ground circuit at the set OFF rpm
Yellow: Normally Open; This will provide a ground source at your desired ON rpm range and remove the ground at the set OFF rpm.
I would think that I would have to use the gray wire, becasue it would control when the system is actually activated. If this is right, Would I connect the ground off the ZEX NMU to the gray wire? Also about the activation switch, what do i connect this to?
Thanks for any help that anyone can provide!!
What I know:
Red: To 12v power
Black: To ground
White: To RPM siginal
What I need to know: Which one of these do I use?
Gray:Normally closed; This will remove the ground source at your desired ON rpm range and complete the ground circuit at the set OFF rpm
Yellow: Normally Open; This will provide a ground source at your desired ON rpm range and remove the ground at the set OFF rpm.
I would think that I would have to use the gray wire, becasue it would control when the system is actually activated. If this is right, Would I connect the ground off the ZEX NMU to the gray wire? Also about the activation switch, what do i connect this to?
Thanks for any help that anyone can provide!!