PDA

View Full Version : Incontinate (non-Chevy) Mouse



Greg Seibert
07-01-2007, 10:35 PM
:eek2: What did I do to deserve this? Had a new assembled 5.0 short block from Ford Motorsport sitt'n in the two-car garage at the house all bundled up in plastic bags over in the corner, right. While rearranging things in there today, I started to move the engine, and out come a handfull of Ole Roy "rich and meaty"nuggets! Started to pull the plastic off, and out comes more Ole Roy. If the little sheet would have just stored the crap in there, it would have one thing, but he jizzed up a couple of cylinder walls, which caused rust and pitting on the jugs with the pistons at BTDC. I then found the whole bottom of the block and the the two rear piston and rod assemblies stuffed all the way up to the wrist pins with Sam Waltons Bird Dog chunks and insulation all over the place.:eek:
Steel wooled the pitting with WD40 and it still looks pretty bad.
Waaaa.

dedpedal
07-01-2007, 10:45 PM
Sounds better than a mid 1960s porn on 8 mm film. But not by much.

PonymanfiveO
07-02-2007, 03:27 AM
Oh hell no!

That sucks. :(