PDA

View Full Version : Can't get t-3650 out



Lexstang
11-10-2007, 04:04 PM
I cannot get this darn transmission out. I have a block of wood and jack under front of oil pan to try and tilt engine back. I am sure I have all the bolts out, cable off, starter out. Even with a come a long around back of tranny I cannot get it more than about 1/2 inch off of engine. What the heck am I doing wrong? Is it common for the input shaft to get that stuck?

08 Vette
11-10-2007, 04:17 PM
If you've got everything unhooked it should slide off! I swapped one in a buddys 01 Cobra. Look again, something must still be connected.
good luck!

todd86
11-10-2007, 06:54 PM
make sure you got all the little bolts out of the flyweel shield and you did take the starter off right. May be a dumb question but you never know.

Lexstang
11-10-2007, 07:28 PM
I just figured it out. Dang longtube headers are hitting on passenger side. I had to be all the way under looking up to see it. SO now I've got to pull the whole k member to get the header off and the tranny out. Good thing I've got vacation week after next. Hope its not too cold.

Black92LX
11-10-2007, 10:38 PM
if you need some extra hands shoot me a PM