1989GT
11-14-2007, 04:07 PM
1986 Chevy S-10: 350 4 bolt main block bored .030 over, Speed Pro flat-top pistons(static compression ratio is 9.8:1 with 64cc combustion chambers), Eagle crank and I-beam rods, Edelbrock E-tec aluminum heads 64cc combustion chambers, Lunati voodoo cam, Edelbrock 750 cfm carb, Edelbrock Vortec RPM air gap intake, Built 700R4, custom aluminum driveshaft and an 8.8 with 3.73 gears, limited slip and 31 spline axles. Autometer gauges, B&M shifter, march billet serpentine belt conversion, Lakewood traction bars, Weld pro-stars...I think that's most of it. Engine was just rebuilt this spring. 5,600 OBO. May except trades.
http://img2.putfile.com/thumb/11/31715591592.jpg (http://www.putfile.com/pic.php?img=7091229)
http://img2.putfile.com/thumb/11/31715591570.jpg (http://www.putfile.com/pic.php?img=7091230)
http://img2.putfile.com/thumb/11/31715591592.jpg (http://www.putfile.com/pic.php?img=7091229)
http://img2.putfile.com/thumb/11/31715591570.jpg (http://www.putfile.com/pic.php?img=7091230)