sprayn93coupe
01-06-2008, 03:43 AM
Used SBF aluminum sr world products heads, fully ported, 2.02 In. 1.60 Ex. ferra valves, double springs good for .600 lift hydraulic roller, guide plates, studs. These heads have been welded on and would be best suited for a naturally aspirated engine due to the porting that has been done. One intake runner needs some work it has a pin hole which allows water in the runner this was caused by a nos backfire on high rev limiter. I am sure anyone at the last UMTR event could hear it on the big end I had to much gear and stayed in it. I have over $2000 in these but I am going different route and would like sell these or trade for pure street parts.
$750
Thanks Jason
$750
Thanks Jason