PDA

View Full Version : Putting C4 in, need help


nos90gt
02-22-2008, 05:40 PM
Just pulled out my TKO600 and putting in a C4. I need to run lines for the cooler. Do you think I will be able to get the fittings and the lines I need at the local part store?
Jeff88coupe
02-22-2008, 06:00 PM
Where is local for you? I used 6an braided line and fitting for my tranny lines.
nos90gt
02-22-2008, 06:02 PM
Napa,Carquest,Autozone.
PaulFiveOh
02-22-2008, 06:08 PM
Why the change between the TKO and C4?

Going turbo? Also, what will you be doing with said TKO?
nos90gt
02-22-2008, 06:43 PM
Sold it to one of my buddy's that is finishing up his car.
PaulFiveOh
02-22-2008, 06:48 PM
Got ya.
Do you have any work in the C4 going in? Valvebody, clutches, bands?
nos90gt
02-22-2008, 06:58 PM
Yeah, it is a Redneck Performance C4. 4200 stalled, full manual, reverse pattern, transbrake valve body.
nos90gt
02-22-2008, 07:02 PM
Car ran with 5spd 11.3x's @ 118mph and 10.6x's with a small shot.
kennebellcobra
02-22-2008, 09:03 PM
Find a place local that can make teflon coated braided hydrolic lines. I used a place called air&hose parker something(can't remember)

I used some wire loom to get the lengths I needed then let them do it and it cost me less than I cound buy the stuff to make it. It's also rated to 450 degrees and 2000lbs pressure. I will never make another AN set up after pricing the difference.