TurboNG
05-21-2008, 12:23 PM
Engine: 1990 302 fresh rebuild roller block. New clevit bearings, ARP rod bolts, ARP main bolts, ARP oil pump shaft, new oil pump, and Oil pan was sand blasted and painted. E303 Cam and Timing chain has about 4k miles or close to…. Stock balancer, under drive pulleys, stock flywheel, stock replaced water pump with about 4k miles on it. $650.00
Heads: Performer RPM- triple valve springs for 600deg. CAM, 3 angle valve job, dec cut .001, new valve guides and seals, 1.6 roller rockers, hardened push rods. Stock valve covers come with heads. $850.00 $900.00 with E303 CAM
Intake: Ported GT-40 intake, 1inch phen. Spacer. Uppers has some cosmetic damage but still looks good and performs great. $450.00
$1800.00 for complete long block
This set up went 11.45 @117mph on my first and only pass at Kill Kare Last year! and a 75hp wet shot. 12.4 on 3rd out of 5 passes made on motor. Everything is now rebuilt and brand new. Heads are not on motor yet but block is ready to go..
Also have stock heads from 1990 block, stock injectors, and another E303 CAM used and a few other misc. items laying around….
(937)765-0207 Dave
Heads: Performer RPM- triple valve springs for 600deg. CAM, 3 angle valve job, dec cut .001, new valve guides and seals, 1.6 roller rockers, hardened push rods. Stock valve covers come with heads. $850.00 $900.00 with E303 CAM
Intake: Ported GT-40 intake, 1inch phen. Spacer. Uppers has some cosmetic damage but still looks good and performs great. $450.00
$1800.00 for complete long block
This set up went 11.45 @117mph on my first and only pass at Kill Kare Last year! and a 75hp wet shot. 12.4 on 3rd out of 5 passes made on motor. Everything is now rebuilt and brand new. Heads are not on motor yet but block is ready to go..
Also have stock heads from 1990 block, stock injectors, and another E303 CAM used and a few other misc. items laying around….
(937)765-0207 Dave