Caster camber plate question.

[DeckerEnt]

I just put the caster camber plates on my coupe tonight. I think they need to come off. The 3 bolt part that goes through the bottom was a tight fit. Which hole should I enlarge to get some more play in the plate? I am thinking of drilling out the single hole a little. Or should I grind on the 2 slotted holes? Keep in mind this is an 81 coupe. Not an 87-93.
Keith

[DeckerEnt]

Well, I grinded the single hole out a bit and now there is enough play that it swings fully. Couldn't find a large enough drill bit so I put a grinding stone on my whiz wheel and just ground it till it fit.
Keith

[Timido]

I dont think it matters which hole you drill out The alignment specs tell the whole story.