PDA

View Full Version : 95 Gt TKO Swap



Orodi
08-22-2008, 10:27 AM
Ok I have talked to a couple people here and there about what to do with the cross member to make my TKO fit. I have everything sitting on my shop floor and I have no idea what they were talking about I was told to cut off a plate and weld it on a little futher back there is no plate to cut off. I also need a 3/4 shim.......any ideas

fst 5pto
08-22-2008, 10:52 AM
You should be able to buy one to allow the swap. I have a 600 and that's what I did....

PaulFiveOh
08-22-2008, 11:17 AM
Shannon would be a good resource for this

facemelter71
08-22-2008, 11:41 AM
I believe they are talking about the crossmember.I had to do it when i put my 3550 in my car.If you re-use the factory x-member than you have to cut or grind out the spot welds on the end of the tubes.Hang on,i have mine right here.Ill take a pic.

kennebellcobra
08-22-2008, 12:02 PM
I believe they are talking about the crossmember.I had to do it when i put my 3550 in my car.If you re-use the factory x-member than you have to cut or grind out the spot welds on the end of the tubes.Hang on,i have mine right here.Ill take a pic.

94-95's are different than fox's the crossmember will not slide. I used a piece of 1/4" steel and drilled holes for the trans and then holes for the mount...it just offsets the mount back. I then made some shims to get it back up to the t-5 height. It's best to take a measurement from the tailshaft center to the body then shim the new trans to that measurement.

facemelter71
08-22-2008, 12:35 PM
I cut mine,but i guess those are different.I have 1/4" plate at my dads if you want it.I used it for some aftermarket seats i had mounted.
This is what i did to mine.
http://img.villagephotos.com/p/2008-1/1296889/x-member.jpg
http://img.villagephotos.com/p/2008-1/1296889/x-member2.jpg
I would size them down but my comp is running slower than hell.