Clutch fork question?

[ricks_85_gt]

Ok i got the bellhousing figured out now i need to know which clutch fork to use. I got a 4cyl T-5 and a SN95 bellhousing goin on a windsor. Does ANYBODY have any idea which one I need, cause obviously I have no fricken clue!:confused:

[facemelter71]

Im pretty sure it wont work.And besides,that T-5 will get blown apart the first time you lay into it.Unless its a built t-5.

[Timido]

You need to use a sn95 trans v-6 or v8 with sn95 bellhousing. The sn95 stuff (input shaft and bearing retainer) is longer than the fox stuff. The 4cly trans has a smaller piliot bearing than the v8 stuff.

[ricks_85_gt]

Well poo..................... Back to the drawing board........... Again!!

[RACEME]

Timido is correct, and with the 4cyl trans, you can't just switch the input shaft like on a v8 one.

[ricks_85_gt]

Well....... anybody got a tranny....... hahaha!!