PDA

View Full Version : need help !!


mb88coupe
10-01-2008, 02:29 PM
will ranger front rotors and axles fit in my fox for 5 lug conversion ?
i thinks it a 95 ranger 2wd
lmk thanks
mike
Stangman
10-01-2008, 03:09 PM
Ranger rotors will work with 4 cyl mustang spindles. Lincoln MK7 rotors w/o ABS will work for 5.0 mustang spindles. And the axle shaft you need from a ranger is out of the older ones, not 100% sure of the exact year, but you need 2 left hand axles from a ranger for the proper length.
mustangjon
10-01-2008, 08:31 PM
84-86 on the mark vii, because the abs went in, during 87 production year, unless you catch early 87 build maybe.
mustangjon
10-01-2008, 08:54 PM
actually the lincoln club verified 85 was year they started putting abs in them, i think 87 was standard all models, so would have to just look
92coupe
10-01-2008, 11:03 PM
You can use any 92 back left side ranger axles.
mb88coupe
10-02-2008, 07:34 AM
what if it has a 8.8 in it? wouldnt i be able to use both ?
Stangman
10-02-2008, 08:17 AM
Nope. All rangers had an offset rear axle no matter what size it was. The drivers side was always longer.

And if it was an 8.8 it would be 31 spline and waaayy too big to fit in the axle and the carrier.
mb88coupe
10-02-2008, 05:12 PM
Nope. All rangers had an offset rear axle no matter what size it was. The drivers side was always longer.

And if it was an 8.8 it would be 31 spline and waaayy too big to fit in the axle and the carrier.



thats what i needed to know does any one have a sn 5lug conversion for sale ? front and rear ?