PDA

View Full Version : procharger pulley's, vortech strut rod f/s



ibstrokin
10-06-2008, 02:47 PM
I have a couple of different pulley's for sale for procharger

1- 8", 8 rib w/stock accessory for 86-93, may fit 94-95 also, not sure, $70

1- 92 tooth procharger cog pulley w/ underdrive accessory, $125

2- Gates polychain 1440 cog belts, new, $35 each

Vortech strut rod, missing adapters for crank and blower, adapters available through vortech, $125

93 coupe
10-06-2008, 03:14 PM
They just put some more out on the table! :lol:

ibstrokin
10-13-2008, 03:59 PM
After a little checking, I believe these are for 94/95, feel free to make offers. Strut rod will fit 79-95

Bill
10-13-2008, 08:15 PM
Are the 1440 Polychain belts 50mm wide?

--Bill

ibstrokin
10-13-2008, 08:26 PM
Belts are 35mm, cog pulley is 50.

Bill
10-13-2008, 11:14 PM
Thanks for the info. I will check the width of the belts we use and get back with you tomorrow.

--Bill

Bill
10-14-2008, 12:28 PM
I checked the current belt and as I thought we run a 50mm wide 1440 belt. We tried a few 35mm wide but we didn't like them as much as the 50mm. Good Luck with the sale.

--Bill

ibstrokin
10-15-2008, 12:48 AM
http://i172.photobucket.com/albums/w23/Ibstrokin/DSC_4472_A.jpg

http://i172.photobucket.com/albums/w23/Ibstrokin/DSC_4473_A.jpg

http://i172.photobucket.com/albums/w23/Ibstrokin/DSC_4474_A.jpg

http://i172.photobucket.com/albums/w23/Ibstrokin/DSC_4477_A.jpg

ibstrokin
10-22-2008, 09:33 PM
Pulleys are sold.