Going to Need 3.8 Heads

[BigBadStang]

Where is a good source to get reman cylinder heads for my 95 Stang. I replaced the head gaskets about 7 years ago, and I have one seeping I think. It has 145k miles on it, and if I take 'em off, I'm sure they would need the valves and stuff done, milled and checked. So I'm thinking on just getting some reman's to keep down time to a minimum since this is my daily driver.

Thanks!

[ibstrokin]

Try OHIO Crankshaft in Greenville, OH. They are about 45 minutes nw of Dayton.

[BigBadStang]

Thanks for the tip. :)
Greenville...the home of Annie Oakley...lol
I'll check them out.

[facemelter71]

Here is a question .I read an article last year about some one putting 4.2L truck heads on a 3.8L.Is this possible?

[BigBadStang]

From what I've read, the 99 & up 3.8 and 4.2 use the same heads with the truck 4.2 using a different intake that wont clear the stock hood on a mustang, but they are interchangeable.