4.6 2v turbo

[mustangbangher]

I been searching for a turbo for my mustang. Im not quite sure what im looking for when it come's to turbo's I have the entire set up already by bought a turbo to small. So im looking for a master power turbo that will be good on my mustang like the a/r and what not... thanks for the help.

[dsmawd350]

i have a garret GT42 74mm, t4 housing, 1.01 a.r

[mustangbangher]

Ya im looking to spend under 600! Don't you have 2? would you want to sell one?

[mustangbangher]

btw how fast does it spool. and what's the back pressure and how big is your down pipe

[dsmawd350]

it has a 5" V-band DP, the back pressure? thats gonna depend on your hotside, heads, and alot more than just my turbo alone? spools gonna depends auto or 5spd, what c.i. motor, spool to what boost level. I'm sure you could see 14psi on a 302 by 3500


but anyways im asking 850 soooo.....

[mustangbangher]

no thanks out of my price range... but what size a/r should i get... and what's a good turbo

[mustangbangher]

also what is a t3/t4 hybrid? good or bad?

[Mike]

A t3/t04 turbo has a t3 exhaust side, and a t4 cool side. Better spool.

Don't put something like that on your car. Get a masterpower T70. You sound like you should do A LOT more research before diving face first into a project like that.

[e5shea]

no thanks out of my price range... but what size a/r should i get... and what's a good turbo

a 57mm turbo would be good for a 2v

[bobtsgt]

start reading up on theturboforums.com A masterpower T70 will work fine for you. There are a couple of vendors on there that sell them. VSracing is where I got mine. A .96 A/R will be good for a 500+ HP set up. If you don't want the higher end HP then go for a smaller A/R to spool a little faster.

[mustangbangher]

start reading up on theturboforums.com A masterpower T70 will work fine for you. There are a couple of vendors on there that sell them. VSracing is where I got mine. A .96 A/R will be good for a 500+ HP set up. If you don't want the higher end HP then go for a smaller A/R to spool a little faster.

Thanks you answered everything I needed.... I already have the entire turbo set up had it running and dynoed just had a turbo to small. Thanks again..

[mustangbangher]

A t3/t04 turbo has a t3 exhaust side, and a t4 cool side. Better spool.

Don't put something like that on your car. Get a masterpower T70. You sound like you should do A LOT more research before diving face first into a project like that.

Already did the entire car was just wondering about the turbo....

[turbostang95]

i did a lot of research/ asking friends,I would do either a master power t70 or the new t76. Both would work great on your car, i did the new t76 with a .96 a/r exhaust housing on my car. The t70 rates at like 800hp maybe a little more and cost $599 and the t76 is suppost to top out at close to 1000hp with a sticker price of $700. As long as the motor is built for the turbo you will like eith one.