PDA

View Full Version : t5 trans cheap


BIZLE
04-22-2009, 10:58 AM
ok i just bought this trans and was going to use it for parts
mainly the input shaft anyhow i found out its a 4 cyl t5 so their is no reason for me keeping it
i have not had it in a car so i know nothing about it but everything seems to be fine as far as shifting it and looking it over
$100 buys it firm or i would trade it for a 70mm tb or alum drive shaft
513-293-0882
trans is complete with shifter no bell
sean
04-22-2009, 01:34 PM
damn, a 4cyl... You had me all excited. I just blew up a 4 cyl t5.lol
Ryan218
04-22-2009, 02:47 PM
is all the needs to be changed to run this in a 5.0 the input shaft?
Xowner
04-22-2009, 03:25 PM
u dont even have to change the input shaft i think? u just need the special pilot bushing double check tho
BIZLE
04-22-2009, 05:18 PM
u dont even have to change the input shaft i think? u just need the special pilot bushing double check tho

yea your right just go to a smaller pilot bearing i forget what you but it for but im sure someone on here will chime in
STREETRODZ1
04-22-2009, 07:03 PM
The pilot we have used was for a GM car, works like a champ.
draggin50
04-22-2009, 07:05 PM
You can go to Autozone and get the pilot bearing for the 2.3 and it fits right in the 5.0 crankshaft. I've done a few of these for people because they like the lower gears in the 4 cyl tranny. Also there is a guy that does machining for me that will make a steel bushing that slides on the input shaft that will allow you to use the stock 5.0 pilot bearing. Either way it will work.
sean
04-23-2009, 01:41 AM
pm sent. what year is it and it is a 5 speed right? I need to get this thing so I can make it to the cruise. Call me as soon as you can and I will be right over.
Thank you sean
sean
04-23-2009, 09:09 AM
dont mean to bother you. I will be in and out all day today. If you can call or text me when you get up. 317-0870.
soslow
04-23-2009, 09:45 AM
just call him sean, clearence is cool
sean
04-23-2009, 10:00 AM
thank you. left a message at that number.
sean
04-23-2009, 10:17 PM
I will keep you up on the progress. Its a little whiney in gear under load. Goes in all gears fine sitting still. When moving 1 and 2 are great. 3 grinds a bit, even at low speeds, 4 is not able to be put it as with 5. When you try to get it out of 3 it doesnt want to come out.