Need a Snout welded on my TQC

[PaulFiveOh]

I need someone (who has done it before) to weld a new snout on my Converter.
It got a little botched but is still new besides the snout issue.

I think Dirtyd0g on here messes with them? Just looking for someone who knows what they're doing since it is a precise job.

PM me contact info. Ready to move right now.

[PaulFiveOh]

Seriously....this is Stangbangerz....really, no one?

[Dirtyd0g]

I think I am the only person around with the equipment to do this. The converte rmust be cut open to do this as the back side has to be trued up afterwards.
Alan

[PaulFiveOh]

Sounds expensive...PMd

[Dirtyd0g]

I sent a reply I think you will be surprised. If there isn't anything wrong with it except the hub the normal charge for most covnerters to cut,clean,replace hub, weld and balance is $75. 9 inch units can be more expensive because of the lack of overlap requiring a renewal ring added to prevent burn through.
Alan