install instructions

[BlazinEagle]

Just picked up the powerdyne bd-11a off flaming87lx but I have never installed one of these before (never even had a supercharged car before). I cannot find instructions online anywhere.
This is going to be going on a 90GT.
Thanks,
Rodney

[Goldeneagle]

I hope you're rebuilding the power plant, and did you get the brackets? If so then all the ones that I have seen and the one I had were on the right hand side. :)

[Goldeneagle]

http://www.corral.net/forums/showthread.php?t=763402

[facemelter71]

Install's on everything but a foxbody.
http://www.powerdyne.com/installation_manuals.htm

[wildstang89]

Rodney, I think I may still have my instruction book for the one I have. I'll have to look for ya. Steve

[BlazinEagle]

Steve that would be great...do you still want this beast of a compressor? If so I do not have my engine hoist anymore so we will need many guys to lift it.
The powerplant was rebuilt a couple years ago with low miles on it. It does not have any shaft play in it. And I need the instructions for a fox!!!! why the hell do they have everything else but that?
-Rodney

[wildstang89]

I forgot all about it. lol My truck is down again though, so is the jeep.
I'll go out to Dad's and look for the instructions.