C9OE big-valve heads!

[mailman]

These are good clean C9OE 351W heads set up for 1.94/1.60 Chevy valves. No valves, no springs on them currently. 3/8 screw-in studs already in. I'll give ya a set of the ARP sleeve/washers to run these heads on a 302 block. These are the best flowing stock castings out there. Looking for $200.

http://i4.photobucket.com/albums/y130/pietsrock/006-1.jpg

http://i4.photobucket.com/albums/y130/pietsrock/005-2.jpg

http://i4.photobucket.com/albums/y130/pietsrock/007-3.jpg

Comp Cams Magnum 1.6 roller-tipped rockers $100, or the heads and rockers for $250.

Located in Yellow Springs, OH 45387. (937) 572-7261.

[mailman]

Bump! Run these heads and not have to worry about spark plug to header interference! Make an offer!

Will trade up or down for 5.0 go-fast parts, nice T5 shifter, nitrous parts, body work, exhaust cutout, etc.

[draggin50]

Do they come with the headers Lol?

[85_SS_302_Coupe]

I have a set of these on my 347, although mine are ported to hell and back. From what i've seen from a few other combos i'm only 20-30rwhp away from similarly built 347s with aftermarket heads. They do perform but to get that level you need to port them. I've also heard from a few people that the GT40 irons used on the '93 Cobra and later Explorers where based off of these heads.

[mailman]

Do they come with the headers Lol?
Sure. Or buy the headers by themselves for $3.79!


I have a set of these on my 347, although mine are ported to hell and back. From what i've seen from a few other combos i'm only 20-30rwhp away from similarly built 347s with aftermarket heads. They do perform but to get that level you need to port them. I've also heard from a few people that the GT40 irons used on the '93 Cobra and later Explorers where based off of these heads.

Very similar runner, but these have 1.94/1.60 valves where the later GT40 heads only had 1.84/1.46 valves.

[mailman]

Bump- OBO!

[mailman]

to the top

[mailman]

ttt...

[mailman]

trade for a turbocharger of some sort?