sticking injector?

[TONYT]

just put a 351 windsor with procharge and went to start it and i believe the number one injector is sticking open pulled all the plugs out and cranked it over and gas is just gushing out of the number 1 hole. i have 55 lb injectoras is there a fix for this or should i buy one new injector any help is appreciated.

[TONYT]

after swapping a new inj in its doing the same thing
turns good,but wont fire
#1 cyl inj makes a clicking noise when key is in on position
it seems to spray an abnormal amount of fuel into cyl prior to starting

[89notch]

Check your injector harness ground

[89notch]

I also had one do this and found a bare wire against the intake

[TONYT]

thanks, but i think the real problem is i 've got the fuel rails plumed wrong

got a new routing from a source that uses the factory style route ,but either i installed it wrong or didnt get all the info

what i have now is
the 2 rails are tied together in the rear
drivers side rail has the return going to regulator(middle of rail)
bottom fitting on regulator is set of for return to tank
front passenger side rail feeds the setup

i think here in is the prob. but i know as much bout this as i do brain surgery
so i need u all to put me on the right track

T-U-A-V-M