how much is to much???

[penceracing]

i made a 1 1/2 spacer for my cobra intake. So the question is how much is to much for the intake when it comes to a intake spacer???

[Squale iii]

Too much and you'll have issues putting a strut tower brace back on...At least I did when I had my notch. Hell, I think I had hood clearance issues too, so I had to put the cowl back on. I cant remember how big my spacer was though.

[penceracing]

yea i dont run one of those. and am running a 4in cowl hood.

[jack90gt]

Wow that's a big spacer...

[87stangbbb]

wood intake,new trend?

[penceracing]

hell ya

[RIXXX93GT]

Whats the reason for the spacer?

[Stangman]

Good luck finding bolts. I actually had to make my own. You may have to do the same.

[Foxxx5oh]

wood intake,new trend?

all of the spacers i have seen for a fuel injected intake have been wood / woodish

[Foxxx5oh]

Good luck finding bolts. I actually had to make my own. You may have to do the same.


allthread + locktite + locking nuts = your friend on bigger spacers

[Walter]

all of the spacers i have seen for a fuel injected intake have been wood / woodish

LOL. Thats phenolic resin and fiberglass/cloth.

[skeptiq]

Ordered mine from Fastenal in Florence, KY near intersection of Empire Connector & Weaver. Just measured the stock ones and added 1/2 inch and ordered them. Cost was < $7 for all the bolts (grade 8 if I remember right).

Later
Ben

[Foxxx5oh]

LOL. Thats phenolic resin and fiberglass/cloth.

oh, welp, theres my somethin learned for the day! sounds a lot like wood when you drop it tho haha

[kennebellcobra]

Spacers will lower the rpm range of the intake too.

[Johnson1134]

why is this in the for sale section?just askin?

[Foxxx5oh]

why is this in the for sale section?just askin?

maybe he is planning on making them to sell?

[Johnson1134]

maybe he is planning on making them to sell?

doesnt sound like it.sounds like he asking a question about the spacer.

[Stangman]

Spacers will lower the rpm range of the intake too.

Shit, in that case let me get rid of my 1" spacer... and hack another 1" off the bottom of my upper intake! :lol: :bigthumb

[penceracing]

well i was thinking about selling them lol... i have heard good things about the spacer i thought i would give it a try

[dsmawd350]

Shit, in that case let me get rid of my 1" spacer... and hack another 1" off the bottom of my upper intake! :lol: :bigthumb

longer runners increase low end torque power and decrese top end. short runners like a single plane, etc. shine in the higher rpms but may lose a little down low

[penceracing]

i had to make one out of plastic the wooden one's kept on braking when cutting out the ports. but it came out pretty good. might be making some more later to sell later. Right now the only ones i have right now is the cobra and the holly systemax gasket for a templet .