View Full Version : WHere to mount fittings for valve cover evac
RIXXX93GT
01-09-2011, 12:49 AM
Going to set my engine up this year with a line from each valve cover going to a catch can. What is the correct placement on the valve cover (top front, top rear) for the fittings and what size fittings are normally used?
Thanks,
RIck
Blowpastyou
01-09-2011, 01:11 AM
I used -12 on the last setup I did, incase I ended up using a vacuum pump. Its a little extra cost over -8 or 10 but not much more. There are alot of options with catch cans with -12 as well. The bungs were placed at the top in the front.
Jeff88coupe
01-09-2011, 11:22 AM
I put 10an fittings in the front of my v/c's to use with either a catch can or vacumn pump. You can see the blue caps on the front of the v/c's in the pic.
http://farm6.static.flickr.com/5089/5229986836_944e49fff2.jpg
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.