Neutral safety switch bypass

[lxenvy]

Ok so i hit the key and nothing.... Jump the relay and she fires up. So, it was a auto now 5 speed. In the dash it has a jumper wire (from the factory) that is still hooked up and i cut the plug next to the tranny with the 4 wires. Got 2 of them together and the key would start it BUT it turns the car over when i turn the key to the ON position the starter starts spinning. I dont have to turn the key over to the START position at all. WTF im so done with freakin wiring.... Any info on this. Google sucks with 1000's of post about other BS. Plz help.. Should i keep it jumped in the dash and still jump it by the tranny or what? Any quick fix or a way around the deal? Thx ppl

[lxenvy]

I know 2 of the 4 is back up lights and other 2 is the switch. I think the 2 back ups are blk and wht and the other 2 for the switch is red/pink purple and pink or something like that??? Errr

[03z06vette]

Did you jump the solenoid or relay?

[lxenvy]

i jumped the wires down by the tranny??? And the clip under the dash by the pedals is already jumped with a plug from the factory

[Gearhead]

i jumped the wires down by the tranny??? And the clip under the dash by the pedals is already jumped with a plug from the factory

don't you have to remove the factory jumper at the pedals when switching from AOD to 5 speed ?? My memory is a little fuzzy on this.
This info might help:

http://www.shortlinegarage.com/2007/09/17/aod-to-t5-a-12-step-program/

http://www.westcoastmustangs.com/articles/tech/t5swap/t5swap.html

see #13 or 14 on this:
http://www.moddedmustangs.com/forums/5-0-mustangs/425-aod-t5-conversion.html

[lxenvy]

and just let it hang? it dosent hook into anything? Thx

[1992MustangDW]

if that doesn't help i can print you out wiring diagrams tomorrow off mitchell at work

[Gearhead]

and just let it hang? it dosent hook into anything? Thx

see above, I posted a couple links

[lxenvy]

if that doesn't help i can print you out wiring diagrams tomorrow off mitchell at work

I think the links will help, If not i will let u know. Thx


see above, I posted a couple links

Yes yes, Thanks alot:bigthumb

[Timido]

If the circuit is jumpered at the 4 pin trans plug and jumpered at the pedel it should start with no nuetral switch. Get a test light and hit start the ignition switch if there is no power to the transmission plug on the start circuit it is wiring or a switch.