2 junk wheels

[jlt2006]

I need 2 wheels with tires. They can be junk. Need them to move the car around.

they are for the front and need to fit 95 5 lug spindles.

LMK if you have anything.

my stock 06 do not fit.

[Kevin1989]

i have 2 that fit on my 01 ranger they fit TIGHT over the hub though. yours if you want them lmk

[Stangman]

Are you rolling your coupe around Jeff? I have two steelies with mix matched tires came from an SN95 v6

[Kevin1989]

^ hes closer too!

[jlt2006]

Are you rolling your coupe around Jeff? I have two steelies with mix matched tires came from an SN95 v6

You still work in Blue Ash?

[Stangman]

Yep. Sure do. I took the wheels down to felicity to scrap but we haven't scrapped yet. So next time I am down there I will get them.

[jlt2006]

okay, appreciate it. I know someone that lives down that way. If it would make it any easier.

Did you want the rotisserie that I used?

[Stangman]

okay, appreciate it. I know someone that lives down that way. If it would make it any easier.

Did you want the rotisserie that I used?


I can grab em probably this weekend if you're not in a rush.

And what did you want for that rotisserie? How does it bolt to the car?

[jlt2006]

Okay on the weekend.

I used a piece of angle iron and it mounts the the bumper support.
I figure $20, that should cover the cost of the iron.

[Stangman]

Okay on the weekend.

I used a piece of angle iron and it mounts the the bumper support.
I figure $20, that should cover the cost of the iron.

Sweet. Works for me!

So all I have to do is get 2 engine stands? (will they clear height-wise when the car is on it's side?)

I will grab the wheels and can meet you monday after work.

Is she ready for paint yet?

[jlt2006]

yes, ready to paint.

The angle iron mounts to an "a" frame. You will need to see it. If you look at the pictures in my project post http://www.stangbangerz.com/forums/showthread.php?t=60154 , there should be pics in there.

They won't fit in your trunk. Its an old weight bench cut into two pieces.
We will figure something out.

[Stangman]

I have a Ranger pick up truck so its all good.

I like it!

[Stangman]

Just looked at that rotisserie... that thing is bad ass...

How much weight will it support?

[jlt2006]

I can only say that I had the coupe loaded on it. Could turn the coupe 360 degree with no problem. The ends are made of 4 inch square tube with .09 wall, the angle I bought to mount to the bumper support is I believe 3/8 thick.