Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
Need help with clutch lever on t5 [Archive] - StangBangerz Forums
PDA

View Full Version : Need help with clutch lever on t5


mwaller5672
05-13-2011, 06:45 PM
I have the transmission together and the lever is in the hole.How in the heck do I get the lever in place without bending the springs.Do I need to take the transmission off the bell housing again. What is the easiest way. I did put a new throw out bearing in it.
Mike
mwaller5672
05-14-2011, 06:34 PM
If someoneknows this could you give me an answer.Kinda holding me up
chris91
05-14-2011, 07:12 PM
If you dont have any luck here Mike, try www.corral.net TONS of good info over there.
foxfreak393
05-15-2011, 10:51 AM
You should always put the fork on the throw out bearing before you put the bellhousing in, I have done it the other way, but it was a pain in the.....
mwaller5672
05-15-2011, 02:00 PM
I'm figureing I will have to take it part of the way off. Chalk it up to a learning experience. I did joing corral Chris and have been reading articles.
Thanks to both of you
Mike