Need help with clutch lever on t5

[mwaller5672]

I have the transmission together and the lever is in the hole.How in the heck do I get the lever in place without bending the springs.Do I need to take the transmission off the bell housing again. What is the easiest way. I did put a new throw out bearing in it.
Mike

[mwaller5672]

If someoneknows this could you give me an answer.Kinda holding me up

[chris91]

If you dont have any luck here Mike, try www.corral.net TONS of good info over there.

[foxfreak393]

You should always put the fork on the throw out bearing before you put the bellhousing in, I have done it the other way, but it was a pain in the.....

[mwaller5672]

I'm figureing I will have to take it part of the way off. Chalk it up to a learning experience. I did joing corral Chris and have been reading articles.
Thanks to both of you
Mike