1/16 NPT tap.

[facemelter71]

I need a 1/16 NPT tap. I need to tap a fitting for a Nozzle. Any one have one I could borrow for ohhhh about 5 minutes While I tap the rest of this fitting that wasnt tapped all the way through.

[Paul408Notch]

Remind me tomorrow and I'll check at work for one. If I have one, just bring over that tie rod nut I've been meaning to get from you and you can have it.

[Dirtyd0g]

I have a handful of 1/8 taps I could give you one. The 1/16 I do not have but I have to place an order with enco for cutters soon I can order you one I doubt it will be more than $5.
Alan

[Adam@S&MMotorsports]

Call me tomorrow i should have one