Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
piston ID help plz [Archive] - StangBangerz Forums
PDA

View Full Version : piston ID help plz


TONYT
07-08-2011, 05:32 AM
i ran across this used windsor setup that has pistons in it marked

245030I26
3298_01_op

the first set of #"s has the beginning chopped off in the eyebrow of the relief
looking to see just what they are and possible comp. ratio's from around 58cc to 64cc

any and all help is gr8ly appreciated,ive been googling and what not but got nothing
draggin50
07-08-2011, 08:19 PM
Do you have a picture of the piston in question?
draggin50
07-08-2011, 08:31 PM
Do you know brand, flat top, 351 based, any other info? Id say by the 030 in the part number its a .030 over piston. KB has a KB246-030 part number for the Windsor.
TONYT
07-08-2011, 11:36 PM
mahle dished 418 stroker
TONYT
07-08-2011, 11:42 PM
found em at cnc motorsports
comp 9.7----64cc
1.5 1.5 3mm ring set
thanx for looking tho guys
draggin50
07-08-2011, 11:52 PM
Cubic inches 418.4 Bore Diameter 4.030 Stroke 4.100 Rod 6.200 Pin 0.927 Compression Height 1.245 Crown Volume -26cc Weight 388 grams 10.3 CR with 58cc 9.7 with 64cc 9.2 with 70cc Part number SBF245030I26

Figured you'd have this already but if not here ya go.