84stang
09-01-2011, 07:25 PM
I have a 66 Fairlane XL that I been gathering parts for about 5 years and just don't have the time to work on it.
It is Wimbledon white with Red Interior. Has a roller 302 short block and AOD installed. I have most of the engine parts to get it going.
I have new headers and full Flowmaster Exhaust built for Fairlanes. I also have a set of 351 headers if someone wanted to go that route.
has 8" rear with 4.62 and spool. I have the stock 3.00 pumpkin also.
I have new wheel cylinders, hoses, master cylinder. Also have a mostly complete Granada disk conversion. New pitman arm and puller.
Body is in pretty good shape except for drivers front fender. I had an accident in the driveway and it got dinged. Fender is fixed it just needs to be repainted.
I have two sets of headlight buckets. One got slightly damaged in the incident.
Have new front and rear bumpers and new headlight rings
There is some rust in the radiator support that is not too bad and should be easy to patch. There is also rust in the cowl area that will need to be fixed. I was going to pull the heater box and just seal off the cowl.
Interior was taken apart but i have all the stuff to put back together. I don't have the console. It is original bucket seat interior. Needs seat covers to be nice.
The floors seem solid.
This car was supposed to be the wife's bracket car but she has lost interest in racing.
There is probably more but can't think of anything at the moment.
I would like to trade it for a decent mustang or would take 5,000.00
Thanks,
Bill
It is Wimbledon white with Red Interior. Has a roller 302 short block and AOD installed. I have most of the engine parts to get it going.
I have new headers and full Flowmaster Exhaust built for Fairlanes. I also have a set of 351 headers if someone wanted to go that route.
has 8" rear with 4.62 and spool. I have the stock 3.00 pumpkin also.
I have new wheel cylinders, hoses, master cylinder. Also have a mostly complete Granada disk conversion. New pitman arm and puller.
Body is in pretty good shape except for drivers front fender. I had an accident in the driveway and it got dinged. Fender is fixed it just needs to be repainted.
I have two sets of headlight buckets. One got slightly damaged in the incident.
Have new front and rear bumpers and new headlight rings
There is some rust in the radiator support that is not too bad and should be easy to patch. There is also rust in the cowl area that will need to be fixed. I was going to pull the heater box and just seal off the cowl.
Interior was taken apart but i have all the stuff to put back together. I don't have the console. It is original bucket seat interior. Needs seat covers to be nice.
The floors seem solid.
This car was supposed to be the wife's bracket car but she has lost interest in racing.
There is probably more but can't think of anything at the moment.
I would like to trade it for a decent mustang or would take 5,000.00
Thanks,
Bill