clutch cables?

[80 hate]

Is buying a STEEDA cable worth it? I just broke my 2nd one so should I just buy a stock one from here on out?
What are you guys running?

[jktruckin06]

A guy told me he was snapping his stock ones and that was one of the best investments made.

[mustang8998]

Yes, stock would be cheaper.

I would try to figure out if there is something about the routing, to make sure it is not kinked, severely bent, etc....

[80 hate]

I checked the routing to make sure its not kinked. Everything looked good. I dont drive the car that often. Could that be an issue? Can you lube the cable?

[sean]

Routing and heat can cause problems. I broke one a month on one of my foxes. The first one was a complete pain to do. By the time I sold the car a barley had to stop the car. Lol

[Blackout]

make sure it's also not running by the exhaust. I have an extra stock cable that is like brand new. I only had it on the car for about an hour and then upgraded to an adjustable unit. It's yours for $30 if you want it. Just let me know.

[inferno50]

I went trough 3 of them due to it being too close to my old headers. I would check for heat damage.

[fuel10922]

I went trough 3 of them due to it being too close to my old headers. I would check for heat damage.

X2...I wrap mine with Thero-Tech heat tape. Only the portion where it runs between the side of the block and the headers.

[NXcoupe]

Steeda cables are the only ones I run. I've had the same ones in my cars for years with no issues. Could be the quadrant is rubbing through it. A guy had one of the UPR triple pick ups and ground it down and smoothed where the cable was rubbing on it, and his issues went away.

[80 hate]

Could be! It broke at the top by the quadrant. And I have a triple pickup quadrant.

[Rick93coupe]

I haven't looked at a clutch cable in many years but I have a stock one here that should be worth 20.00 if you want it.

[full force]

don't ever get the coated ones, they SUCK

I like the Steeda ones myself, never have issues..

[80 hate]

Well I got the cable replaced today. Not a bad job at all. I replaced it with a motorsports non-adjustable cable. I did have to trim alittle off the bracket to clear the headers. Thanks for all the advise and input. You guys ROCK!