Fox Body 5-lug front conversion

[2Fast4You]

Currently on my 85 GT I am parting out, everything you will need. Brand new rotors and pads on them.

$100.00 O.B.O.

Shayne 513-233-8857

[draggin50]

Which rotors are these Shayne?

[2Fast4You]

I was told that this is a Lincoln set up but I am not able to confirm.

[draggin50]

What's the diameter of the rotors?

[2Fast4You]

Appr. 10.5"

[draggin50]

Ok so it wasnt the 10 inch ranger rotors. I may be interested in them. I'll call ya tomorrow.

[2Fast4You]

OK, talk to you then.

[2Fast4You]

These will be scrapped tomorrow if no one calls me wanting them.

[2Fast4You]

Here are a couple of photos, has some light surface rust from sitting.

[2Fast4You]

I decided to remove these from the chassis prior to scrapping so I do still have these, someone make me an offer. They look worse in the pictures than what they are, some light cleaning and they will be brand new again.

[OnebadGL]

I am very interested. haven't made it far enough to know what all I need. what were they originally from? what spindles do you have?

[03z06vette]

these are the mark8 rotors...

[OnebadGL]

can anyone tell me what struts these would need?

[2Fast4You]

can anyone tell me what struts these would need?

It still uses the Fox Body struts.

[1bad5.0]

Could you pm me your bottom dollar im thinking about going 5 lug , more wheels choices and I think 5 lugs look better than 4

[Stangman]

these are the mark8 rotors...

Mark 7.

8's are slide on rotors.

THE rotor to buy for swapping a 5.0 car over in the front are the Lincoln Mark 7 rotors W/O ABS.

4cyl cars use the ranger rotors I believe, because of the diameter and bearing differences.

[1bad5.0]

what is the cheapest way to get 5 lug axle's , but i dont wanna put it 5 lu axles and they break on first pass on sticky tires

[Stangman]

2 right hand Aerostar axles, or 2 left hand ranger axles, except there is a specific year range on the ranger axles that I don't remember right now

[1bad5.0]

i heard it was two right side ranger axles but wouldnt they be weaker then the ones that in it now from the factory . This is a orig v8 car and the rangers are 4cyl . I just dont wanna swap em out and the first time i am at the track it break

[Stangman]

an axle is an axle. Its literally the same axle but with a 5 lug hub. And its def the left hand axle on rangers. Right hand on aerostars.

Best to just start a new thread rather than clutter up Shayne's FS ad.

[Moody]

I'm trying to get rid of some 28 spline 93 cobra axles that came in my ford racing cobra R brake kit.

[2Fast4You]

Gone, please close it up.