GREAZY
03-17-2012, 02:10 PM
82 GT
Started on this project about three years ago. The car is rust free. It did have a little spot on the front floor on drivers side, but I put a patch in it. I also put a 1/4 on the pas side. It was not rusty, just had some damage from long ago that had been covered up. The underside from the torque boxes back has been stripped and painted. The engine compartment and floor were stripped and painted. It also has 2 rust free doors. I have the dash, door panels, 1/4 trims and other small interior parts.
8.8 rear with 3.73 and new poly bushings
weight jacker lower control arms
southside upper control arms
motor sport heavy front control arms
new kyb shocks and struts
caster camber plates
sn95 front brakes
302 roller motor - I was going to rebuild
17" bullet wheels with good tires
set of v6 wheels with tires
I also have all the parts that were taking off. ( boxes and boxes of parts )
$1650 or $1350 without bullet wheels
David
513-575-2785
Started on this project about three years ago. The car is rust free. It did have a little spot on the front floor on drivers side, but I put a patch in it. I also put a 1/4 on the pas side. It was not rusty, just had some damage from long ago that had been covered up. The underside from the torque boxes back has been stripped and painted. The engine compartment and floor were stripped and painted. It also has 2 rust free doors. I have the dash, door panels, 1/4 trims and other small interior parts.
8.8 rear with 3.73 and new poly bushings
weight jacker lower control arms
southside upper control arms
motor sport heavy front control arms
new kyb shocks and struts
caster camber plates
sn95 front brakes
302 roller motor - I was going to rebuild
17" bullet wheels with good tires
set of v6 wheels with tires
I also have all the parts that were taking off. ( boxes and boxes of parts )
$1650 or $1350 without bullet wheels
David
513-575-2785