Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
electrical problems [Archive] - StangBangerz Forums

PDA

View Full Version : electrical problems



akagreg3
07-16-2012, 02:00 PM
anyone near hamilton be willing to come help me track down why my car wont start?
1993 mustang lx 5.0
iv changed the dash and tail light harness also trans harness all is hooked up and turns over fine, iv done the EFI wont start check list, it gets power to the coil- both wires and TFI but no spark iv got 2 rotors and caps neither one works, ecm is grounded to apron and neg battery, getting power to the ignition switch and ecm not sure if its getting power to every wire its supposed to be tho, no power to the fuel pump- relay or inertia switch? :mad: hooking a wire up to the test and ground does nothing

331lx
07-16-2012, 03:13 PM
Carb swap..... Lol I suck at electrical stuff good luck with this

Stangman
07-16-2012, 04:07 PM
Got your block grounded to the firewall well?

Stick or auto car? Clutch safety?

akagreg3
07-16-2012, 06:17 PM
Got your block grounded to the firewall well?

Stick or auto car? Clutch safety?

it was originally a 5 speed car but the hack that i bought it from changed it to an aod, and it ran when i bought, the trans harness i put in is out of an 1993 mustang automatic dash harness came out of the same car

yea iv not messed with the engine other then changing the starter solenoid

akagreg3
07-16-2012, 06:34 PM
everything seem to be working right -back up lights turn signal brake lights hazard lights, dash is still out of car, cluster is hooked up


Rawr i hate electrical stuff too,, this why i need help

akagreg3
07-17-2012, 09:03 AM
any advice?
could the ecm gone bad just siting? id hate to buy a new one @250$ and it not be that