Parse error: syntax error, unexpected '<' in /opt/bitnami/apache2/htdocs/forums/archive/global.php(117) : eval()'d code on line 1
drive shaft bolts - what size [Archive] - StangBangerz Forums
PDA

View Full Version : drive shaft bolts - what size


mwaller5672
10-01-2012, 07:03 PM
What size are the bolts to bolt your drive shaft to rear end.
Mike
331lx
10-01-2012, 10:28 PM
Thread size or head size?
Stangman
10-01-2012, 10:33 PM
Head size is usually 12 point 12mm. Can't remember the threadsize off hand. I'm sure you can find it on the internet easilly. I bet ARP has it listed
maverick
10-01-2012, 10:37 PM
I just did a clutch/flywheel swap, 12 point 12mm is correct. I'm not sure about the thread size
mwaller5672
10-01-2012, 10:45 PM
I found the ford part number. It was 12 1.75' of course I bought 4 50's so they don't fit thanks for your responses