Cammed Mach Dyno results

[na svt]

It's a stock longblock with custom cams and short runner intake along with LTs, march fluid damper, March wp and hydraboost pulleys, CAI and 4.30 gears.
SAE numbers were 376/325.
http://img502.imageshack.us/img502/2816/stocklongblock226226110.jpg (http://imageshack.us/photo/my-images/502/stocklongblock226226110.jpg/)

[Gearhead]

Nice !! :bigthumb I'd like to pick your brain one day about Modular engines....

[2Fast4You]

Good numbers, makes for a fun street car.

[na svt]

Good numbers, makes for a fun street car.

With some sticky tires this much pwoer is good for getting a full weight car into the 11s. The next combo I do like this may get have intake runners that are about 3/4" longer which will increase tq but may also increase average power in the range the engine sees during the quarter.

Still trying to hit 390 with a stock longblock and stock based intake.

[Gearhead]

You dynoed it in TX ? Or was this a combo you specd out for somebody ?

[na svt]

You dynoed it in TX ? Or was this a combo you specd out for somebody ?

I spec'd the cams and made the intake.

[Blkcobra01]

Can you buy those march p/s and water pump pullies still? Thought they were discontinued they are 00 cobra R pullies aren't they?

[cstreu1026]

I know you can still get the power steering and alternator pulleys. I have them on my car.

[na svt]

I'll pm ya the part numbers tomorrow.

[na svt]

Below are links to the March fluid damper and accessory pulleys. The 4" alt pulley is a good mod if you're not running the small diameter damper.

http://www.summitracing.com/parts/MCH-640-08/ hydraboost
http://www.summitracing.com/parts/MCH-1158-08/ damper
http://www.summitracing.com/parts/MCH-116/ 4” alt pulley
http://www.summitracing.com/parts/MCH-1172/ water pump pulley

[Blkcobra01]

Thanks Cam and NA SVT!

[na svt]

Thanks Cam and NA SVT!

The alt pulley needs a little material removed from it to put the belt in alignment.