Need Ideals on Low Profile Filter/Velocity Stack

[devous1]

We're running into a wall on one of my current projects. We had a custom radiator built with an internal water pump, fan and shroud. The V7 is too close to it to use an elbow of any type. The car is two hours away so I don't know the exact measurements.

I need suggestions on what to use. Obviously this is going to be a street car so some sort of low profile high volume filter is my first choice. Second would be to go with a velocity stack with a screen at the very minimum.

http://i1291.photobucket.com/albums/b545/Devous1/A807B6A7-F515-458F-ACC0-BC09D12D7D09-4156-000005BE7B645FF5.jpg

I don't have any side shots with the V7 and radiator in.

[Adam@S&MMotorsports]

Why not shorten the radiator so that you aren't sucking hot air off of it?

[devous1]

It was a custom order an cost a ton. I wanna keep the radiator as is this year and drive the car. Next winter there is going to be a big change in the blower system.

[Adam@S&MMotorsports]

It was a custom order an cost a ton. I wanna keep the radiator as is this year and drive the car. Next winter there is going to be a big change in the blower system.

Then move the radiator to the other side of the core support...