PDA

View Full Version : fs: BES 310'' complete


bangingears
02-23-2014, 04:40 PM
I am selling one of my old engines. BES did the short block and performance clinic did the top end. engine ran 11.70's with gt40p heads, now has a lot better set of heads $2300

-310'' stock block, season, filled to h20 holes, and sonic checked
-early 2m crank with lots of work, 28 oz balanced
- eagle rods, ross xl flat-tops with a good ring package, h-bearings
-milodon race pan, has a bung if ya wanna add turbo/blower
-holley systemax alum heads made by brodix, titainium retainers, good springs
-ford roller rockers
-anderson ford camshaft
-arp head studs, arp rod bolts, arp main studs
-holley systemax intake
-sfi balancer
1992MustangDW
02-23-2014, 08:54 PM
damn i wish i was not poor! glws
Rick93coupe
02-23-2014, 09:21 PM
Is it fresh?
What's the compression?
Is it streetable being Half filled?
NO SHOT
02-23-2014, 09:28 PM
Is it fresh?
What's the compression?
Is it streetable being Half filled?

My 408 was very streetable half filled..
Applejaxx95vert
02-23-2014, 09:40 PM
yea all the same questions rick asked.
Rick93coupe
02-23-2014, 09:40 PM
My 408 was very streetable half filled..

You didn't have any issues keeping it cool?
bangingears
02-24-2014, 11:01 PM
Is it fresh?
What's the compression?
Is it streetable being Half filled?

the bottom end has a few years on it, the top end is completely fresh. The comp ratio is approx 10;1 and it always ran very cool on the street, never over 165-170 degrees. I have some pics, but for some reason the uploads are getting an error.
bangingears
02-24-2014, 11:10 PM
http://i292.photobucket.com/albums/mm34/bangingears1/Mobile%20Uploads/310complete.jpg (http://s292.photobucket.com/user/bangingears1/media/Mobile%20Uploads/310complete.jpg.html)
Rick93coupe
02-25-2014, 12:11 PM
Which cam is in it? Trying to figure out if it's a N/A or power adder grind.
NO SHOT
02-26-2014, 12:37 PM
You didn't have any issues keeping it cool?

No it wasn't any different than when it wasn't...
Rick93coupe
02-26-2014, 12:41 PM
No it wasn't any different than when it wasn't...

Makes me wish I would have done my Windsor but the block had already been machined when I started hearing about half fills. :rolleyes:
bangingears
03-02-2014, 02:55 PM
sold, lock it up please