Driveshaft questions.....going back to the basics lol

[graysonracin]

Swapping a 90 foxbody from auto to 5-speed, will I need a different driveshaft for sure? I know it was something with the yokes being different or ? Ive been outta the game for some years, so ive forgotten a lot of the "mustang stuff" I used to know. Also the crossmember and exhaust hanger are different correct? I know there are tons of articles on this swap, but also a lot of nonsense that creates other questions and confusion. Thanks for any input!

[draggin50]

I always used the same driveshaft for both I think. Its been a while... I think the automatic driveshaft had the weighted input shaft yoke though. The aluminum driveshaft works for both.

The crossmember is the same but Ive had to grind down the welds and move the tubes. The exhaust hanger is the same.

[Gearhead]

Same driveshaft will work. The exhaust hanger bracket is different I believe. But, I think I just cut off the hangers from the h pipe in the past. Need a 5 speed pedal assembly ? I have 3 of them I think...

[graysonracin]

I have the pedals already , thanks for info guys!