Rear end work

[84fox]

Who does everyone use for rearend work? I have a 93 8.8 housing. Looking to have 9" ends installed with factory width along the ring and pinion setup after the cutting and welding is done and I have it powder coated.

[Maximus]

Who does everyone use for rearend work? I have a 93 8.8 housing. Looking to have 9" ends installed with factory width along the ring and pinion setup after the cutting and welding is done and I have it powder coated.

Brad & Jason at Tin Soldier Racecars.
859-359-5068.

[dta15]

I used Babbitt bearing in Columbus

[Rick93coupe]

Mike Pieron, he's over off of Diamond Mill and Wolf Creek Pike area. He cut down my 8.8, installed 9" ends, welded the tubes, installed a ford explorer rear brakes and cut it down 3/4" per side. He's also a Mosier dealer.

[Kwik92GT]

Mike Pieron, he's over off of Diamond Mill and Wolf Creek Pike area. He cut down my 8.8, installed 9" ends, welded the tubes, installed a ford explorer rear brakes and cut it down 3/4" per side. He's also a Mosier dealer.

+1 for Mikey P

[k062693w]

Doesn't Mike Bell (Dayton Performance, NXCoupe on here) have a jig for doing 8.8s and for putting on 9" ends ???
I know he can set up the gear set too ...

[S281SC]

Yes he does. He did a great job on my brother's rear axle. 9" ends welded tubes and all. He is also a moser dealer.


Sent from my iPhone using Tapatalk

[NXcoupe]

I appreciate it guys, but unfortunately I am covered up with work at the moment and couldn't get to it for a while. I am still taking tune appointments, gear installs and trans repairs as time allows.

[84fox]

Awesome, does mike have a shop or contact number? Tried google searching and did not find him. I'm out of Dayton so local definitely would be a plus ! Thanks

[S281SC]

Mike Bell is the nxcoupe right above your post. He said he is currently unavailable for that. But he does good work if you are able to wait. As he pointed out above.


Sent from my iPhone using Tapatalk