FS: Trick flow top end for a 9.5 deck block

I'm changing things up a bit for next year, so I'm going to sell my heads and intake to begin with.

The heads are 56cc highports with 2.055 titanium intake valves and 1.625 SS exhaust valves, setup for a hydraulic roller. They were fully ported by Pauls automotive before I bought them and gasket matched to a 1262R intake gasket. The small chambers are better for someone with a N/A high compression combo, unless you want to run a big dish. The intake is the TFS R-box for a 90mm throttle body.

Heads & intake. Would consider selling the rockers too. $1800 with Comp 1.72 rockers, $1650 without.


My car went in the 9.40's on 16# with a very slow boost ramp with this combo at 3350#

Ok, I sold the box upper. I'm left with the heads and matching trickflow lower intake. Heads were just decked, valves were lapped and they are ready to go. 205cc intake runners, titanium retainers and 10° locks. $1200 firm.

SOLD