As the title says I have a 1989 Honda CR 250 with a big bore kit which makes it a 265. This is as far as you can safely take a older 250 out to. The big bore kit was done by MaxPower engines. The kit cost me around $600, it was installed a few years ago and the bike was trail ridden that year. The bike sat for a while after that, and I did get it out about a year and a half ago to ride it with some friends. The front fork seals were replaced for the one ride I did over a year ago. I do have some misc. extra parts that will go with the bike. It shows normal wear for a '89, but has always run good for me. The only thing that I would probably do is clean the power valves and put a new plug in it and it should be ready to ride. If you have any questions about the bike feel free to ask. I am asking $600 for the bike with any extra parts I can find.
