Getting about 3 psi.
Getting about 3 psi.
Joe
Did you make sure the fire cone was installed on the wastegate seat when you installed it to the flange?
2014 CTS V-sport
2006-teen Black CCSB Powerstroke
I got the heads blocked off at the exhaust side. It’s building pressure. I have some air escaping the wastegate and some escaping my welds. I’m going to have to weld the exhaust more and figure out how to have it seat better or get different style wastegate.
Joe
Nice!
Is your car leaf spring or coils?
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
Gotcha. What all does it take to put the 8.8 in it? Same width?
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
I will have to buy a mount kit and shorten one sides axle. It will be 57” wide instead of the Volvo’s 55” width. I’ll probably get it drilled to 108x5 to match the Volvos pattern.
Joe
Hard to beat the ole 8.8. Everyone uses the explorer rear ends. I have one here for the S10 me and the boy are going to build later.
Gotta watch out for rusted axles tubes over the passenger side where they put a sticker. Seen a few rusted completely through now. Right by the leaf spring U bolt.
1992 Mustang LX Coupe, 302, PA C4 and On3 70mm.
1993 Reef Blue hatch, 347, 3550, and a kit.
1992 Gould GT project...
wow. this has gotten intense.
wow. that would be sitting low if you're hitting the ds on a hard launch. Cant wait to see it at the track.
There are currently 3 users browsing this thread. (0 members and 3 guests)