Who does everyone use for rearend work? I have a 93 8.8 housing. Looking to have 9" ends installed with factory width along the ring and pinion setup after the cutting and welding is done and I have it powder coated.
Who does everyone use for rearend work? I have a 93 8.8 housing. Looking to have 9" ends installed with factory width along the ring and pinion setup after the cutting and welding is done and I have it powder coated.
http://stangbang.tripod.com/ Where all this began!
http://stangbang.tripod.com/twisted/ Vinny
1984 Mustang build @craig_btr on Instagram
I used Babbitt bearing in Columbus
Mike Pieron, he's over off of Diamond Mill and Wolf Creek Pike area. He cut down my 8.8, installed 9" ends, welded the tubes, installed a ford explorer rear brakes and cut it down 3/4" per side. He's also a Mosier dealer.
Rick
Rick90lx@yahoo-dot-com
6.27625 liters of turbocharged goodness
Doesn't Mike Bell (Dayton Performance, NXCoupe on here) have a jig for doing 8.8s and for putting on 9" ends ???
I know he can set up the gear set too ...
Aaron
F**K Photobucket !!!
Yes he does. He did a great job on my brother's rear axle. 9" ends welded tubes and all. He is also a moser dealer.
Sent from my iPhone using Tapatalk
#2 - 2020 DD Challenge List
1997 Cobra - C heads, Cams, Sullivan intake, long tubes, homemade cai, 4.30, strange axles, e85, chromoly cage
2000 Saleen S281SC - factory "stock"
Awesome, does mike have a shop or contact number? Tried google searching and did not find him. I'm out of Dayton so local definitely would be a plus ! Thanks
Mike Bell is the nxcoupe right above your post. He said he is currently unavailable for that. But he does good work if you are able to wait. As he pointed out above.
Sent from my iPhone using Tapatalk
#2 - 2020 DD Challenge List
1997 Cobra - C heads, Cams, Sullivan intake, long tubes, homemade cai, 4.30, strange axles, e85, chromoly cage
2000 Saleen S281SC - factory "stock"
There are currently 1 users browsing this thread. (0 members and 1 guests)