Seeing if anyone has had a similar issue or If you can shed some light on this for me. I have a 2014 mustang GT. I drove it to my shop and installed my hellion single turbo kit. I had to extended my O2 sensors to go from about where ABS module is to top of trans where the plugs for them are. Car is not tuned yet but don’t think that would code my issue. I’m getting no reading for the O2s and also getting codes for both O2s bank 1-2 sensor 1 and then 3 codes for camshaft actuators. Is there a fuse that controls power for both of these? And before someone ask I triple checked to make sure O2 sensors were wired properly during extending them. Any insight would be great. It’s a 2014 GT, literally all I did was install scavenger pump and installed turbo kit then extended the O2 sensors.