Ok so here is the build thread, most of the actual engine work is going to happen this weekend. Should be getting my harness in, get the steering rack swapped over to one with the mounts pre-fabbed, and possibly get the motor in the car. Here is the car as it sits, minus the exhaust and interior





The motor going in is a 1993 5.0 H.O. with shortie headers, though the drivers side needs modified to fit around the steering shaft.

I am probably going to go catless, to dual mufflers, out the same side of the car where it originally exited

I am considering running a mega-squirt setup though I don't know much about them and not sure if I really need it for a mild build setup.

Parts I still need: (if you have these pm me with what you want for them)

93 gauge cluster, and dash harness

93 T-5 compatible drive shaft ( just need front half so I can merge with rear of 240sx shaft)

Radiator for 5.0 engine (might go new, depends on what I can get)

T-5 short shifter

AC compressor eliminator

pulleys for 5.0 engine

Also wouldnt mind help installing the harness and working on it in general... if your feeling helpful or bored, come hang out, and drink some free beer. My shop is in Harveysburg, OH.