sweet..... cant wait to hear the beast
sweet..... cant wait to hear the beast
speed kills, but it beats going slow
Matt
2004 Torch Red Cobra
2006 Torch Red F-150
Pulled a cover out of the junkyard, cleaned it up and mounted the pump/filter. Tank should be here thurs. Just need to get down to the speed shop and get some -10 and -6 line, and have Adam load a base tune to start it!!!
![]()
Looks good man, how soon will it be running?
A week or so.
Sweet
Looking forward to seeing it run. You have a pm.
http://stangbang.tripod.com/ Where all this began!
http://stangbang.tripod.com/twisted/ Vinny
1984 Mustang build @craig_btr on Instagram
http://stangbang.tripod.com/ Where all this began!
http://stangbang.tripod.com/twisted/ Vinny
1984 Mustang build @craig_btr on Instagram
gimme a call before you start it... I would love to be in attendance...
speed kills, but it beats going slow
Matt
2004 Torch Red Cobra
2006 Torch Red F-150
WERD!!!!![]()
Tank is here!!!!! I took a buncha pic's for Bob.
![]()
going in here soon!!!!
![]()
better get to work fool!!!!!!!
Shit, at this rate yours will be running and MJs will be painted....KICK ASS!!!!!![]()
http://stangbang.tripod.com/ Where all this began!
http://stangbang.tripod.com/twisted/ Vinny
1984 Mustang build @craig_btr on Instagram
Well poop....I was gonna hang the tank this morning, but i don't have the vent plug thingy that goes in the hole in front of the hole where the pump normally goes.![]()
thanks to a fellow SBZ member I got the -10 feed line in 2nite. Thanks Brad (atbracin) I could'nt build this car without ya!The car is ready to pour gas in, check for leaks, and get Adam from Cincy Speed out here to load the tune and start it!!!!!!
Hey Brad, here's how it was routed, should be OK once the heat wrap from the airplane is on the fuel lines near the muffler.
![]()
curious why you didnt opt for a traditional sump at the rear of the tank?
i think you should be fine. mine was the same way. better call me when you start thast beast.
Looks sweet Joe, you do NICE WORK!
There are currently 1 users browsing this thread. (0 members and 1 guests)