After driving around a couple times with the new wheel setup. I knew I needed to upgrade to some stickier tires before I kill myself. The 345 Nittos aren't cutting it. Theyre completely dangerous in my opinion for any car that makes descent power. Only one problem. They only make 19" and 20" cup wheels for the Corvette. I needed at least a 18" drag radial but ever drag setup available is just plain ugly. I looked at weld, ccw and a few others. I didn't want to spend $5,000 on an entire setup of wheels and tires. I just wanted rear wheels with drag radial tires and everything available didn't match. So after searching and searching and searching. I found out they make these wheel in a replica version for 1994-2002 Trans Ams and Camaros. I checked the offset on them and found the front wheels have the offset I need. Only problem is they only 18"x8" wide. I purchased them and sent them to weld craft to have them widened 4". Now I have nearly a matching drag set up.