I decided on which block to go with. I wanted keep the car numbers matching. I'm sending my block to ERL for a all aluminum 427ci 6 bolt block with 1/2" ARP head studs, dragon slayer crank, billet I beam rods and weisco pistons. Upgraded everything I could. I don't want to do this again. They claim they have cars with over 1800hp with this block. With a couple running 6's in the 1/4 mile. If you're familiar with the Ohio Boys or Ray Litz. This is the exact block they use. Still haven't decided on which 6 bolt heads I want to go with. For fuel I'm going with ID1700 injectors, triple walbro 485 pumps, controller, all stainless lines and fittings and all the wiring. This should be enough fuel to run E85 to 2000hp. Once it's done it should look like the block below. They have finished short blocks but like I mentioned before. I want to stay numbers matching. Another thing I've been thinking about is upgrading to a F1x Procharger. There's a quite a few Vettes putting out 1500+rwhp with a good combination. I'll decide once I add up all the parts. Im currently using the 3.33 pulley. It's biggest pulley for my 2200r. So im basically barely using it to its potential. The car ran 10.4 @ 104mph hitting the brakes before 1000' mark. I feel if the track would of been better and I ran a full pass. I would of had a 9 second pass.