I'm back at it again! My shoulder is getting better finally. I'm tearing out the bottom end and probably getting it bored and honed. The bore Diameter is spot on according to my bore gauge but there is step/groove at the area where the rings stop at right at full upstroke. It would be good to get this cleaned. I wonder if I could just run a ball hone and get it smoothed out. I've only honed one motor and plus one cylinder before this. I didn't have to do much work on those motors because the bores we're in decent shape. Maybe any of you guys can chime in before I decide to take it to a machine shop next week.
Just checking if my engine lift was big enough to reach.
Reply With Quote